Free delivery on orders over £149
Always Low Prices! No Gimmicks!
LifestyleBlinds.com :: Cordless Roller Blind Fitting and Trouble Shooting Instructions

Cordless Roller Blind Fitting and Trouble Shooting Instructions

Fitting Instructions: Roller Spring

STEP 1


crb-step1-bracket1
crb-step1-bracket2

Fitting the blind

Brackets can be top, side or face fixed to any flat surface Check that the rolled up fabric is not obstructed by the brackets.

STEP 2

SPRING SIZE/OPTION ADDITIONAL MEASUREMENT
25mm Internal 20mm
25mm External 25mm
36mm Internal 32mm
36mm External 38mm
Figure 1

To calculate the positioning of the brackets use figure 1 to add the relevant spacing to the width of the blind fabric.

Install the brackets so that the measurement reflects the outside-to-outside distance of the brackets.

STEP 3

Fitting the blind

a) Using external spring system

Make sure the blind fabric is completely rolled onto the roller tube. Fit the round pin end into the right hand bracket (figure 2).

crb-step3-figure2
Figure 2

Ensure enough pressure is kept on the pin end to prevent it being detached from the bracket and insert the spring end into the bracket (figure 3).

crb-step3-figure3
Figure 3

STEP 4

b) Using Internal spring system

Make sure the blind fabric is completely rolled onto the roller tube. Fit the spring end into the straight edge bracket (figure 4).

crb-step4-figure4
Figure 4

Insert the round plastic part into the round pin end (figure 5)

crb-step4-figure5
Figure 5

Ensure enough pressure is kept on the spring end to prevent it being detached from the bracket and slide the plastic part upwards into the bracket until you hear it click into position.

crb-step4-figure6
Figure 6

INFORMATION

Tensioning the spring

If the fabric does not wind up completely when the blind is operated, greater spring tension can be applied as follows;

- Pull the blind down 250mm from its uppermost position and lock off

- Remove the blind carefully from the brackets ensuring the spring isn’t unlocked and roll the material back onto the roller tube by hand.

- Replace the blind into the brackets and check for correct tension If the tension is still insufficient, repeat above steps.

Download a pdf of Cordless Roller Blind Fitting and Trouble Shooting Instructions
 
 

By clicking “Allow All”, you agree to the storing of cookies on your device to enhance site navigation, analyse site usage, and assist in our marketing efforts. Find out more